$25.00 +gst
Suitable for Creatbot D600 Pro 2 & D1000 3d printers.
These are genuine Creatbot supplied 24V 60W cartridge heaters which can handle up to 450C reliably.
Creatbot high temp hot ends support up to 420C so please be mindful the heater you use.
Not for older D600s, F430, F160, or PEEK edition 3d printers.
Standard Tube Cartridge Heater that slots inside the hot block. Has a small connector to plug on the board so its really easy to install.
The cartridge heater slots into the hot end of a 3d printer & heats it, to melt the plastic that flows in.
Over time, the heater needs to be replaced.
In order to handle the high temperatures, the contacts of these heaters are arc welded (not soldered).
So buying a new heater is the best option as it comes with pre-connected wires which you just plug into your head PCB easily.
A new heater offers consistent heating, which makes your extrusion smooth, & thus your printer prints clean lines.
This improves part strength & interlayer adhesion.
We don’t recommend generic 40W heaters as they only go to 250C reliably.
